What's inside the boxes?

  • SumUp 21.5" screen (includes power supply and cables)

  • Straight bracket (includes 4 screws)

  • SumUp Air

  • SumUp card reader holder (includes 2 screws)

  • Port cover and 2 screws

  • USB cable

  • Wall mount bracket

  • 4x M4x12mm Screw

  • 4x M5x12mm Screw

  • 4x M6x12mm Screw

  • 4x M6 Screw

  • 4x Washer

  • 4x 8x40mm Wall Plug

  • Instruction leaflet

  • Pole stand

  • Vesa mount bracket

  • Allen key

Hardware options for mounting:

  • Four screws for mounting to wood counter

  • Four bolts and hex nuts for mounting to non-wood counter

Hardware set up

  1. Grab the pole and lift the cover from its bottom to reveal the four holes and then secure it to your counter.

  2. Using the provided hardware that best suits the surface of your counter, place the pole with its bottom large hole facing the back of the Kiosk (the Kiosk power supply can be run the pole).

  3. Take the SumUp Air card reader holder and attach it to the narrow end of the straight bracket. Align the two little bumps on the bracket with the card reader holder and secure them using the two black screwers.

  4. On a flat and secure surface, place the Kiosk display upside down with the ports on the right side.

  5. Connect the power supply to the top port labeled “DC” and the USB cable to the bottom port labeled “USB”.

  6. Insert the port cover into place and secure it with the two small silver screws.

  7. Place the straight bracket over the four holes in the center of the display, sliding it to position the card reader holder as close to the screen as possible.

  8. Place the vesa mount directly over the four holes in the center of the display and secure it with the four screws provided with the straight bracket.

  9. Position the SumUp Air card reader into its holder and connect it using the micro USB cable.

  10. Once your SumUp Kiosk display is securely fastened, slide the vesa mount onto the pole.

  11. Rotate the Kiosk screen into position and use the allen key to tighten the three small screws located at the top of the pole.

  12. Connect the power supply to the Kiosk screen and plug it into an outlet.

  13. Finally, remove the protective screen cover.

Cleaner setup

You can run the power supply through the pole and out of the top for a cleaner setup.